Page Comparison

...

All future updates to the PRO Hub can be completed from the PRO Connect Application.

STEPSSTEP 1: UPDATE YOUR HUB’S BOOTLOADER

1. Power Off your PRO Hub using the power switch on the front panel
   

   Image Added

2. Start the PRO Connect Application on your PC or Mac ComputerClick on the updates icon

3. Navigate to the PRO Hub Bootloader update utility within PRO Connect
   

   Image Added

4. Follow the on-screen instructions to update the Hub’s Bootloader

   1. It is important to be deliberate and follow all on-screen instructions

5. Follow the on-screen clean-up steps after the update is complete

STEP 2: UPDATE YOUR HUB’S FIRMWARE VERSION

1. Power on your PRO Hub using the power switch on the front panel

2. Connect the same USB-B cable used in STEP 1 above from your computer to the PRO Hub’s main card
   

   Image Added

3. Navigate to the HB_PRO external drive in your file system. This drive should present itself immediately when you connect the Hub to your computer.
   

   Image Added

4. Replace the ofile.rbf in the HB_PRO drive with this file:

   View file
   name ofile.rbf

5. Copy the CONFIG.TXT file from the HB_PRO drive into your computer’s file system

6. Disconnect the USB Cable from your PRO Hub. This should cause your Hub to automatically reboot and apply the new version.

7. Follow the Quick Start Guide here:

8. Check the PRO Connect application to ensure your Hub has compatible firmware with PRO Connect.