IMPORTANT: This guide should only be run if you have first attempted to use the PRO Connect PRO Hub FPGA Only update utility and were unsuccessful.
IMPORTANT: This guide should only be run if you have first updated your PRO Hub’s bootloader to v2.24.
STEP 1: Turn off your Hub’s power switch and disconnect all USB cables from your Hub.
STEP 2: Turn on your Hub’s power switch and wait 10 seconds.
STEP 3: After waiting 10 seconds, connect a USB Type B 2.0 cable from your computer to your Hub.
STEP 4: Navigate to the HB_PRO drive in your computer’s file system.
STEP 5: Download the “ofile.rbf” file to the HB_PRO drive. You should replace the existing “ofile.rbf”. You cannot rename this file, it must be “ofile.rbf”. You can download the file by clicking on it here:
STEP 6: You will also need to convert your CONFIG.TXT file and apply it to your Hub. Copy the CONFIG.TXT file from the HB_PRO drive to your Desktop on your computer.
STEP 7: Eject the HB_PRO drive from your computer.
STEP 8: Turn off your Hub’s power switch.
STEP 9: Disconnect the USB Cable from your Hub and wait 2 seconds.
STEP 10: After waiting 2 seconds, turn on your Hub’s power switch.
STEP 11: Wait for your Hub to show up in the PRO Connect Device list.
STEP 12: Navigate to the File Tab on the Hub’s Config page.
STEP 13: Import the CONFIG.TXT file from your computer’s Desktop and Apply that configuration.
CONGRATULATIONS YOUR INITIAL PRO HUB UPDATE IS COMPLETE!
If you have any issues during this upgrade process please https://heartechnologies.com/support/techsupportform.html