Updating your PRO Hub to be compatible with the PRO Connect Application is a multi-step process.
The minimum versions required for your PRO Hub are:
Firmware v8.0
Bootloader v2.24
All future updates to the PRO Hub can be completed from the PRO Connect Application.
STEP 1: UPDATE YOUR HUB’S BOOTLOADER
Power Off your PRO Hub using the power switch on the front panel
Start the PRO Connect Application on your PC or Mac Computer
Navigate to the PRO Hub Bootloader update utility within PRO Connect
Follow the on-screen instructions to update the Hub’s Bootloader
It is important to be deliberate and follow all on-screen instructions
Follow the on-screen clean-up steps after the update is complete
STEP 2: UPDATE YOUR HUB’S FIRMWARE VERSION
Power on your PRO Hub using the power switch on the front panel
Connect the same USB-B cable used in STEP 1 above from your computer to the PRO Hub’s main card
Navigate to the HB_PRO external drive in your file system. This drive should present itself immediately when you connect the Hub to your computer.
Replace the ofile.rbf in the HB_PRO drive with this file:
Copy the CONFIG.TXT file from the HB_PRO drive into your computer’s file system
Disconnect the USB Cable from your PRO Hub. This should cause your Hub to automatically reboot and apply the new version.
Follow the Quick Start Guide here:
Check the PRO Connect application to ensure your Hub has compatible firmware with PRO Connect.